NOTE: If you run into any issues after upgrade, perform a hard reset on the router and reconfigure from scratch, do not use an nvram backup Click on 'Upgrade' and wait at least 5 minutes for the router to complete flashing and rebooting.Select downloaded firmware image file 'Browse'.Go to Administration -> Firmware Upgrade.Download one of the following file options from the /broadcom folder.Browse to the dd-wrt.v24_mini_wrt300nv11.bin you downloaded, and hit upgrade.Download DD-WRT v24 Mini from: /broadcom/dd-wrt.v24_mini_wrt300nv11.bin.Set your computer to auto IP and auto DNS.Go in and set your user name and password by carefully typing each of them in.Wait until you can access the dd-wrt webgui at 192.168.1.1.Browse to the dd-wrt.v24_mini_wrt300n.bin you downloaded, and hit upgrade.Go to Administration, Firmware upgrade, in the linksys webgui.Log back into the router (router should have defaulted back to 192.168.1.1 user/pass admin).Plug a lan cable from your computer to a LAN port on the router.Set your computer to a static IP address of 192.168.1.7 Subnet mask to 255.255.255.0.Do a proper HARD reset on your router.MAC addresses for MAC filtering, SSID, pass-phrase, static DHCP entries, etc) Log-in and find any settings you might want to keep and copy them down or cut and paste them to notepad or another editor.Read the peacock announcement found here:.Download DD-WRT v24 Mini from: broadcom/dd-wrt.v24_mini_wrt300n.bin.See Where do I download firmware? for links. Linksys WRT300N v1.1 Installation Procedure Hardware Defaults (with Linksys firmware).(As of September, 2009) WRT300N version 2 is NOT supported.

Linksys 192 168 1 1